Product:
Breathable styrene-acrylic paint for interiors
Top quality product that gives the treated surfaces a satin appearance and high breathability. Accurately formulated, easily applied and very high yield.
For interior surfaces such as cement, gypsum, plasterboard and two-coat plaster.
- Catalog number
- Commercial line
- Sector
- Type
- Last revised
- COV
- [PR-ID-STI326]
- PROFESSIONALE
- WATER-BASED PAINTS
- styrol
- Rev.: 4.0 - 14/12/2021
VOLATILE ORGANIC COMPOUNDS EU limit value VOC (Directive 2004/42 EC) Pitture opache per pareti e soffitti interni (Cat A/a) BA 30 gr/lt (2013) Acristil max contains 30 gr/lt di VOC
Can be diluted with water. Can be mixed with CIPIR colourants or with the "ChròmaSystem" colouring system.
Store the product at a temperature, no lower than 5°C out of direct sunlight. The product, stored and sealed in the original packages, keeps for a period of 2 (two) years.
On surfaces treated with sealers and/or suitable bases, the product covers 5÷6m²/lt for two coats.
The empty jar and washing residue of the used equipment must be disposed of, according to local regulations in force.
To apply with a brush, dilute at 15÷20% for the first coat and 10÷15% for the second. To apply with a wool roller, dilute at 20÷25% for the first coat and 15÷20% for the second. To apply with a spray, dilute at 25÷30% for the first coat and 20÷25% for the second.
In normal temperature conditions (22°C) and relative humidity (60%), the surface is dry to the touch in 3÷5 hours and can be painted over after 24 hours.
Use at ambient temperatures between 10°C and 30°C. Avoid application in case of strong rain, wind and high sunlight.
CYCLE: On new walls: make sure the substrate is perfectly dry and then proceed in applying the first coat of "FIXCIPIR" fixative. After at least 12÷18 hours, the first coat of the product can be applied. After a further 24 hours, the application can be completed with the second coat of Acristil.
On gypsum and plasterboard: after checking that the surface is dry and clean, as well as appropriately filled and prepared, a first coat of "CIPIRFOND" covering fixative, diluted with maximum 15÷20% water can be applied. After at least 12÷18 hours, the first coat of Acristil can be applied. After 24 hours, the application can be completed with the second coat of Acristil.
WARNINGS: Mix the product well before use.
NOTE: Ideal environmental conditions: temperature: min. +8°C - max +35°C relative humidity<75%.
Ideal substrate conditions: temperature: min. +5°C - max +35°C - humidity<10%.
It is recommended to apply the product in favourable climatic conditions as indicated.
Keep the product out of the reach of children.
in favourable climatic conditions as indicated. Applying the product in unsuitable environmental conditions, negatively affects the drying time, compromising the optimal result of both the aesthetic characteristics and its performance.
Do not apply on fresh and alkaline substrates; wait for it to cure (generally four weeks).
Use in a well-ventilated area.
CIPIR ensures that the information is provided to the best of its experience and technical-scientific knowledge; nevertheless, it cannot assume any responsibility for the results obtained as application conditions are beyond its control.
- barcodeformatocolore
- 17 lt()
- dim. mm(PxLxH)pz.imballo
- 305x305x3221
