Product:
Continuous mineral coating with potassium silicate base
Continuous mineral coating with potassium silicate base, inorganic pigments, fine sands and selected quartz, specific additives that give the product excellent colour stability over time and strong protection from mould formation. Water vapour permeable and excellent breathability of the applied film.
On two-coat plaster, cement, insulation systems, concrete, gypsum, plasterboard and roughcast plaster. It is widely used in the renovation and decoration of the walls in the historic centers.
Available in thicknesses: Finest, M1, M2
- Catalog number
- Commercial line
- Sector
- Type
- Last revised
- COV
- [PR-RV-MNR348]
- PROFESSIONALE
- COATINGS
- minerals
- Rev.: 4.0 - 14/12/2021
VOLATILE ORGANIC COMPOUNDS EU limit value VOC (Directive 2004/42 EC) Pitture per pareti esterne di supporto minerale (Cat A/c) BA 40 gr/lt (2013) IntoSil max contains 40 gr/lt di VOC
Can be diluted with water.
Store the product at a temperature, no lower than 5°C out of direct sunlight. The product, stored and sealed in the original packages, keeps for a period of 2 (two) years.
Store the product at a temperature, no lower than 5°C out of direct sunlight. The product, stored and sealed in the original packages, keeps for a period of 2 (two) years.
The empty jar and washing residue of the used equipment must be disposed of, according to local regulations in force.
The product is ready to use.
Consumption depends on the particle size: very fine type: 0.5÷0.8kg/m² type M1: 1.4÷1.8kg/m² type M2: 2.0÷2.3kg/m²
Use at ambient temperatures between 10°C and 30°C. Avoid application in case of strong rain, wind and high sunlight.
CYCLE: On new substrates: make sure that the plaster has reached the ripening of at least 28 days, check that the surface is dry, clean, without the presence of dust or little consistenti.Applicare parties then a fixative "FIXCIPIR" diluted with water in the ratio of max 1 part of product in 1 parts of water. Wait at least 12/18 hours then apply the coating IntoSil.
On already painted or damaged substrates: proceed with accurate and complete removal of the old paint from the support, in addition to any other parts not perfectly bonded to the surface. In the case of the presence of mold, it is recommended to treat the walls with "RISANMUR". Verified that the wall is completely dry and dusted, we proceed with the application of fixative high penetration microparticles "FIXCIPIR" spent can be applied 12/18 hours IntoSil.
WARNINGS: Mix the product well before use. To apply outdoors it is recommended to protect the treated surface from humidity and rain for at least 48 hours after applying the product.
NOTE: Ideal ambient conditions: temperature: min. +8°C max. +30°C relative humidity <70%. Ideal substrate conditions: temperature: min. +5°C max. +30°C - humidity <10%. It is recommended to apply the product in favourable climatic conditions as indicated. Applying the product in unsuitable environmental conditions, negatively affects the drying time, compromising the optimal result of both the aesthetic characteristics and its performance.
Do not apply on fresh and alkaline substrates; wait for it to cure (generally four weeks).
Use in a well-ventilated area.
CIPIR ensures that the information is provided to the best of its experience and technical-scientific knowledge; nevertheless, it cannot assume any responsibility for the results obtained as application conditions are beyond its control.
- barcodeformatocolore
- 5000 g()
- 25 kg()
- dim. mm(PxLxH)pz.imballo
- 220x220x2031
- 292x292x3641
