Product:
Paint for walls with a Hydro Pliolite base.
Hydro Pliolite based. Penetrates into the pores of treated surfaces, making them water repellent without altering the breathability and appearance.
Protects from humidity, dirt and mould, two-coat plaster, reinforced concrete, stone claddings and exposed brick cladding. Water and atmospheric agent resistant, makes the substrate water repellent and therefore protects it from corrosion.
- Catalog number
- Commercial line
- Sector
- Type
- Last revised
- COV
- [PR-PS-APT350]
- PROFESSIONALE
- SPECIAL PAINTS
- acrylic floors and roofs
- Rev.: 4.0 - 14/12/2021
VOLATILE ORGANIC COMPOUNDS EU limit value VOC (Directive 2004/42 EC) Pitture per pareti esterne di supporto minerale (Cat A/c) BA 40 gr/lt (2013) PlexiFas max contains 40 gr/lt di VOC
Can be diluted with water. The product cannot be mixed
Store the product at a temperature, no lower than 5°C out of direct sunlight. The product, stored and sealed in the original packages, keeps for a period of 2 (two) years.
On surfaces treated with sealers and/or suitable bases, the product covers 12÷15m²/lt for each coat.
The empty jar and washing residue of the used equipment must be disposed of, according to local regulations in force.
The product is ready to use.
In normal temperature conditions (22°C) and relative humidity (60%), the surface is dry to the touch in 2÷3 hours and can be painted over after 18 hours.
Use at ambient temperatures between 10°C and 30°C. Avoid application in case of strong rain, wind and high sunlight.
CYCLE: On new substrates that have never been painted: make sure the surface to be treated is perfectly clean, dusted and dry. Proceed with the first coat of PlexiFas. After at least 12 hours, the second coat can be applied.
On previously painted substrates: Completely remove any old paint. Dust and make sure the surface is perfectly dry. Proceed with the first coat of PlexiFas. After at least 12 hours, the second coat can be applied.
WARNINGS: Mix the product well before use. Applying the product in unsuitable environmental conditions, negatively affects the drying time, compromising the optimal result of both the aesthetic characteristics and its performance. The drying process and polymerization for the application of PlexiFas in ideal environmental conditions, is complete within 8÷10 days. If the product should be subject to run-off rainwater in this period, stains and/or semi-transparent drops (streaking), this phenomenon is temporary, it does not affect the quality of the product and can be removed by pressure washing, or it will self-remove in subsequent rainfalls. It is recommended to protect the surface from rain and humidity for at least 48 hours after applying the product.
NOTE: Ideal environmental conditions: temperature: min. +8°C - max +35°C relative humidity<75%.
Ideal substrate conditions: temperature: min. +5°C - max +35°C - humidity<10%.
It is recommended to apply the product in favourable climatic conditions as indicated.
Keep the product out of the reach of children.
in favourable climatic conditions as indicated. Applying the product in unsuitable environmental conditions, negatively affects the drying time, compromising the optimal result of both the aesthetic characteristics and its performance.
Use in a well-ventilated area.
CIPIR ensures that the information is provided to the best of its experience and technical-scientific knowledge; nevertheless, it cannot assume any responsibility for the results obtained as application conditions are beyond its control.
- barcodeformatocolore
- 750 ml()
- 5000 ml()
- 17 lt()
- dim. mm(PxLxH)pz.imballo
- 108x108x1276
- 220x220x2031
- 305x305x2851
- barcodeformatocolore
- 750 ml()
- 5000 ml()
- 17 lt()
