Sealing coloured covering base with odourless solvent.
Special resin based sealing odourless solvent. Suitable to treat and prepare different types of masonry surfaces, new, old, damaged, flaky or not very consistent. Suitable to strengthen the treated surfaces deep down, besides evening out the absorption. It can be applied also at temperatures lower than 0°C as long as the substrate is not damp. Recommended as a preparation base coat on premixed mortar substrates outdoors and indoors. Prevents flaking, blistering, efflorescence, and the non-uniform appearance of the finishing colour, thanks to its excellent resistance to alkalis.
Suitable for interiors and exteriors, for old and flaky walls, as it has high penetration strength. Excellent as a base coat on new walls of cement, fibre-cement and plaster, before applying products as acrylic water-based paints, acrylic-siloxane, continuous plastic coatings, acrylics and acrylic-siloxane binders.
VOLATILE ORGANIC COMPOUNDS EU limit value VOC (Directive 2004/42 EC) Primer fissanti (Cat A/h) BS 750 gr/lt (2013) PlexiPrimer pigmentato max contains 750 gr/lt di VOC
Can be thinned with dearomatized white spirit. The product cannot be mixed with other painting products.
The product can be stocked also below the temperature of 0°C and out of direct sunlight. The product, stored and sealed in the original packages, keeps for a period of 2 (two) years.
On surfaces treated with sealers and/or suitable primers, the product covers 8÷10 m²/lt for each coat.
The empty jar and washing residue of the used equipment must be disposed of, according to local regulations in force.
To apply with a brush, dilute at 15÷20% for the first coat and 10÷15% for the second. To apply with a wool roller, dilute at 20÷25% for the first coat and at 15÷30% for the second. To apply with a spray, dilute 25÷30% for the first coat and 20÷35% for the second.
In normal temperature conditions (22°C) and relative humidity (60%), the surface is dry to the touch in 3 to 5 hours and can be painted over after 24 hours.
Use at ambient temperatures between 0°C and 30°C. Avoid application in case of strong rain, wind and high sunlight. It is good to protect the surface from rain and moisture for at least 48 hours after applying the product.
CYCLE: On new substrates: make sure that the walls are dusted and perfectly dry, repair any defects and/or cracking, then apply a coat of PlexiPrimer pigmentato. After 12÷18 hours, the first coat of the desired finish can be applied.
On old substrates: accurately clean the surface of old non-adherent paint and remove other peeling parts. If there is mould, treat the walls with PlexiPrimer pigmentato. Check that the substrate is perfectly dry and dusted and then apply a coat of PlexiPrimer pigmentato. Wait for at least 12÷18 hours before applying the first coat of the desired finish.
WARNINGS: Mix the product well before use. To apply outdoors it is recommended to protect the treated surface from humidity and rain for at least 48 hours after applying the product.