Product:
Smoothing adhesive paste for interiors and exteriors.
Plastic smoothing adhesive based on acrylic copolymer resins, mineral fillers of various particle size and specific additives. Particularly resistant to atmospheric agents and ensures perfect anchorage on treated substrates.
Product particularly suitable for bonding expanded polystyrene, expanded polyurethane insulating panels on walls and ceilings and directly on cement, concrete and plaster supports.
It is also indicated for smoothing over old plastic coatings, cementitious plaster and cement blocks. It can also be mixed with Portland 325 cement to increase the thixotropy and therefore accelerating setting times during the bonding phase.
- Catalog number
- Commercial line
- Sector
- Type
- Last revised
- COV
- [PR-RV-PLC355]
- PROFESSIONALE
- COATINGS
- continuous plastic
- Rev.: 4.0 - 14/12/2021
VOLATILE ORGANIC COMPOUNDS EU limit value VOC (Directive 2004/42 EC) Pitture per pareti esterne di supporto minerale (Cat A/c) BA 40 gr/lt (2013) Rasatura plastica max contains 40 gr/lt di VOC
Can be diluted with water. The product can be mixed with Portland 325 cement.
Store the product at a temperature, no lower than 5°C out of direct sunlight. The product, stored and sealed in the original packages, keeps for a period of 2 (two) years.
On surfaces treated with sealers and/or suitable bases, around 0.800 kg/m² of product is needed for bonding and 1.200 kg/m² of product for smoothing each mm of thickness.
The empty jar and washing residue of the used equipment must be disposed of, according to local regulations in force.
The product is ready to use, but can be slightly diluted with water.
In normal temperature conditions (22°C) and relative humidity (60%), the surface is dry to the touch in 4÷6 hours.
Use at ambient temperatures between 10°C and 30°C. Avoid application in case of strong rain, wind and high sunlight.
CYCLE: On interior and exterior substrates, make sure the plaster is cured for a period of at least 28 days in normal temperature and relative humidity conditions. Check that the surface is clean and dry, free of oil and grease. Residues of old paint or glue, peeling parts or inconsistent parts must be removed by accurately cleaning the substrate by brushing and then fixing with "FIXCIPIR" or "LACCA 140W". At least 18 hours after applying the fixative, proceed with bonding or smoothing.
WARNINGS: Mix the product well before use. To apply outdoors it is recommended to protect the treated surface from humidity and rain for at least 48 hours after applying the product.
NOTE: Ideal ambient conditions: temperature: min. +8°C max. +30°C relative humidity <70%. Ideal substrate conditions: temperature: min. +5°C max. +30°C - humidity <10%. It is recommended to apply the product in favourable climatic conditions as indicated. Applying the product in unsuitable environmental conditions, negatively affects the drying time, compromising the optimal result of both the aesthetic characteristics and its performance.
Do not apply on fresh and alkaline substrates; wait for it to cure (generally four weeks).
Use in a well-ventilated area.
CIPIR ensures that the information is provided to the best of its experience and technical-scientific knowledge; nevertheless, it cannot assume any responsibility for the results obtained as application conditions are beyond its control.
- barcodeformatocolore
- 25 kg()
- dim. mm(PxLxH)pz.imballo
- 305x305x2851
