Product:
Water-based impregnating agent for wood
Acrylic resin based hydro-impregnating agent with specific additives to fight mould in wood and protect against sunrays. Totally odourless, therefore it is particularly suitable for treating wood surfaces in closed or poorly ventilated areas.
For treating interior and exterior wood surfaces.
- Catalog number
- Commercial line
- Sector
- Type
- Last revised
- COV
- [IU-IM-IMA534]
- IDEALI & UTILI
- PRIMERS AND FINISHES FOR WOOD
- impregnating acrylic
- Rev.: 4.0 - 14/12/2021
VOLATILE ORGANIC COMPOUNDS EU limit value VOC (Directive 2004/42 EC) Vernici e impregnanti per legno per finiture interne/esterne (Cat A/e) BA 130 gr/lt (2013) Impregnante protettivo all'acqua max contains 130 gr/lt di VOC
Can be diluted with water. Can be mixed with the chart colours.
Store the product at temperatures no lower than 5°C, out of direct sunlight, being careful to close partially used packages well.
The product covers 6÷8m²/lt for two coats.
The empty jar and washing residue of the used equipment must be disposed of, according to local regulations in force.
The product is ready to use.
In normal temperature conditions (22°C) and relative humidity (60%), the surface is dry to the touch in 1 hour and can be painted over after 24 hours.
Use at ambient temperatures between 10°C and 30°C. Avoid application in case of strong rain, wind and high sunlight.
CYCLE: Make sure the substrate is perfectly dry, clean and without impurities. Eliminate any little imperfections from the surfaces by sanding, and then apply the first coat of Impregnante protettivo all'acqua in the desired colour. If necessary, a second coat can be applied only after 18 hours. After 24 hours, the finishing product can be applied.
It cannot be used on wood that has already been treated with any type of filmogenic finish.
WARNINGS: Mix the product well before and during use. To apply outdoors it is recommended to protect the treated surface from humidity and rain for at least 48 hours after applying the product.
NOTE: Ideal environmental conditions: temperature: min. +8°C - max +35°C relative humidity<75%.
Ideal substrate conditions: temperature: min. +5°C - max +35°C - humidity<10%.
It is recommended to apply the product in favourable climatic conditions as indicated.
Keep the product out of the reach of children.
in favourable climatic conditions as indicated. Applying the product in unsuitable environmental conditions, negatively affects the drying time, compromising the optimal result of both the aesthetic characteristics and its performance.
Use in a well-ventilated area.
CIPIR ensures that the information is provided to the best of its experience and technical-scientific knowledge; nevertheless, it cannot assume any responsibility for the results obtained as application conditions are beyond its control.
- barcodeformatocolore
- 2500 ml(IMH25859) Durmast
- 2500 ml(IMH25852) Walnut
- 2500 ml(IMH25851) Dark walnut
- dim. mm(PxLxH)pz.imballo
- 172x172x1602
- 172x172x1602
- 172x172x1602
- barcodeformatocolore
- 2500 ml(IMH25859) Durmast
- 2500 ml(IMH25852) Walnut
- 2500 ml(IMH25851) Dark walnut
