Product:
Special paint for concrete pools
Based on chlorinated rubber resin select pigments and acid-resistant additives, having good resistance to the acidity of chlorinated water.
Used for the protection and decoration of tanks and swimming pools.
- Catalog number
- Commercial line
- Sector
- Type
- Last revised
- COV
- [IU-PS-SIE680]
- IDEALI & UTILI
- SPECIAL PAINTS
- synthetic inner and outer
- Rev.: 4.0 - 15/12/2021
VOLATILE ORGANIC COMPOUNDS EU limit value VOC (Directive 2004/42 EC) Pitture monocomponenti ad alte prestazioni (Cat A/i) BS 500 gr/lt (2013) Vernice antiacida per bordi piscine antisdrucciolo max contains 500 gr/lt di VOC
Keep the product at a temperature no lower than 1°C out of direct sunlight. The product, stored and sealed in the original packages, keeps for a period of 2 (two) years.
On surfaces treated with sealers and/or suitable bases, the product covers 8÷10m²/lt for each coat.
The empty jar and washing residue of the used equipment must be disposed of, according to local regulations in force.
To apply with a brush, dilute at 5÷7%. To apply with a wool roller, dilute at 5÷7%. To apply with a spray, dilute at 8÷10%.
In normal temperature conditions (22°C) and relative humidity (60%), the surface is dry to the touch in 2÷3 hours and can be painted over after 18 hours.
Use at ambient temperatures between 5°C and 30°C. Avoid application in case of strong rain, wind and high sunlight.
CYCLE: On new substrates: make sure the substrate is perfectly dry, clean and dusted. Apply a coat of the product, thinned with about 10% of nitro thinner. After at least 8 hours, apply the second coat of Vernice antiacida per bordi piscine antisdrucciolo thinned with about 2% of nitro thinner. If it is considered necessary for aesthetic reasons or to enhance the roughness of the base, apply a third coat of the product after 8 hours.
On already painted substrates: accurately clean the substrate by using a pressure washer, check the consistency of the surface to be treated, removing any loose or peeling parts. After having cleaned and checked that the substrate is perfectly dry, the first coat of the product, thinned with about 5% of nitro thinner can be applied. After at least 12 hours apply the second coat of the product, thinned with about 10% of nitro thinner. Fill the pool with water after at least 3 days after concluding painting.
WARNINGS: Mix the product well before use.
- barcodeformatocolore
- 500 ml()
- 2500 ml()
- dim. mm(PxLxH)pz.imballo
- 109x109x856
- 165x165x1602
