Product:
Product designed to prepare the base in glossy and opaque wood finishes for interiors.
The filler can be applied with a brush or spray, dries very quickly and does not cover the grain of the wood. It limits and makes the natural tendency of the wood homogeneous to absorb the finishing product.
It has excellent filling strength and sanding capacity, permitting perfect smoothing.
- Catalog number
- Commercial line
- Sector
- Type
- Last revised
- COV
- [IU-FF-ISS021]
- IDEALI & UTILI
- PRIMERS AND TOPCOATS
- synthetic insulation
- Rev.: 4.1 - 19/01/2022
VOLATILE ORGANIC COMPOUNDS EU limit value VOC (Directive 2004/42 EC) Impregnanti per legno che formano una pellicola di spessore minimo (Cat A/f) BS 700 gr/lt (2013) Fondo Turapori al solvente max contains 630 gr/lt di VOC
Can be diluted with nitro thinner.
Shelf life: 12 months, with a maximum T of 40 ° C, in sealed tin, covered and protected from frost.
Practical yield: 10÷12 m²/l
Consumption: 80÷100 ml/m²
The empty jar and washing residue of the used equipment must be disposed of, according to local regulations in force.
Nitro thinner up to 50%, depending on the absorption of the wood
In normal temperature conditions (25°C) and relative humidity (50%), the surface is dry to the touch in 1 hour and can be painted over after 6 hours.
Use at ambient temperatures between 10°C and 30°C and Relative Humidity <70%. Avoid application in case of strong rain, wind and high sunlight.
CYCLE: Surface preparation:
• Apply on a clean, dry surface free from natural resins and free from grease, wax and contaminating material. Moisture content should not exceed 20%
On new wood: it is recommended to remove the hair by sanding with a fine grain (P240 or finer) before application, especially if the hair is in patches.
• On deteriorated wood: damaged areas must be carefully sanded until a healthy support is obtained.
• On already varnished wood: enamels, transparent varnishes, etc., must be sanded or treated with a paint remover until the paint film is completely removed and the surface must then be treated as if it were new wood.
• Apply two coats of finish after sanding. It can also be painted over with two components.
WARNINGS: Mix the product well before and during use. To apply outdoors it is recommended to protect the treated surface from humidity and rain for at least 48 hours after applying the product.
NOTE: Ideal environmental conditions: temperature: min. +8°C - max +35°C relative humidity<75%.
It is recommended to apply the product in favourable climatic conditions as indicated.
Keep the product out of the reach of children.
in favourable climatic conditions as indicated. Applying the product in unsuitable environmental conditions, negatively affects the drying time, compromising the optimal result of both the aesthetic characteristics and its performance.
CIPIR ensures that the information is provided to the best of its experience and technical-scientific knowledge; nevertheless, it cannot assume any responsibility for the results obtained as application conditions are beyond its control.
- barcodeformatocolore
- dim. mm(PxLxH)pz.imballo
- barcodeformatocolore