Product:
Polyamide cured epoxy primer, inert pigmented,
Polyamide cured epoxy primer, inert pigmented, “surface tolerant”, suitable as adherence coat on old paints and on galvanized steel, or as primer on cement, concrete, and fiber-glass.
Suitable as tie-coat on zinc rich primers.
- Catalog number
- Commercial line
- Sector
- Type
- Last revised
- COV
- [PR-PS-SIE021]
- PROFESSIONALE
- SPECIAL PAINTS
- synthetic inner and outer
- Rev.: 4.2 - 30/08/2022
VOLATILE ORGANIC COMPOUNDS EU limit value VOC (Directive 2004/42 EC) High performance two-component paints (Cat A/j) BS 500 gr/lt (2013) Primer Epofarb EC max contains 500 gr/lt di VOC
Can be diluted with water.
Shelf life
• 18 months, with T max of 100°F, in sealed drum, indoors and protected against freeze.
Practical coverage
• 5,6 m2/kg – 75 micron
Practical consumption
• 180 g/m2 – 75 micron
Cleaning up
• Water immediately after use
The empty jar and washing residue of the used equipment must be disposed of, according to local regulations in force.
Air spray - Thinning 5÷10 % v/v
Roller, brush - Thinning 0÷5 % v/v
Drying times at 68°F – 50% R.H.
• to touch 4-6 h
• to recoat 12 h
Environmental conditions
• Temperature: 50-120°F
• Relative humidity <75%
CYCLE: Surface preparation
• Not heavy service: dry abrasive blast to Sa 2 – Sa 2.5 (SSPC-SP6; SSPC-SP10) with an anchor profile of 25-75 micron; in alternative, mechanical abrasion to remove rust and calamine.
• Galvanized steel: remove white salts by mechanical means ad thoroughly degrease with thinner F2. If steel has not been exposed to weather for at least 6 months, lightly blast with fine abrasive to ensure good adhesion.
• Cement: clean and primer coat of sealant EPOPRIM.
WARNINGS: Do not use during rain, fog and wind.
Do not add water for dilution before having stirred thoroughly the two components, better by mechanical mean.
When air bubbles are forming during application, increase dilution.
If a anti-slip finish is desired, scatter sand on the surface after the first coat; then, before applying the second coat, sweep off the exceeding.
NOTE: Ideal environmental conditions: temperature: min. +8°C - max +35°C relative humidity<75%.
Ideal substrate conditions: temperature: min. +5°C - max +35°C - humidity<10%.
It is recommended to apply the product in favourable climatic conditions as indicated.
Keep the product out of the reach of children.
in favourable climatic conditions as indicated. Applying the product in unsuitable environmental conditions, negatively affects the drying time, compromising the optimal result of both the aesthetic characteristics and its performance.
Do not apply on fresh and alkaline substrates; wait for it to cure (generally four weeks).
Use in a well-ventilated area.
CIPIR ensures that the information is provided to the best of its experience and technical-scientific knowledge; nevertheless, it cannot assume any responsibility for the results obtained as application conditions are beyond its control.
- barcodeformatocolore
- dim. mm(PxLxH)pz.imballo
- barcodeformatocolore